Digital PWM DC 12V 5A LED Dimmer

PWM
DC 12V 5A Digital Dimmer

The 12V Dimmer Kit V2 is an especially
efficient PWM (pulse-width modulation) controller for 12V loads up to 60 watts.
It features a single dial control for 0-100% output as well as a pushbutton
input that steps through five preset power levels.

Supply voltage: 3-16V DC

Rated load current: ＜5A
Max

Output power: 12V＜60W Max

PWM Frequency: 140Hz.

Output: 1 channel

Working temperature: -20-60°C

size: L63.4*W28*H12.8 mm

User Controls

Dial adjustment: Rotate the dial from far left (0% output) to far
right (100% output).
Pushbutton: Push the button to advance from 0% (fully off), 1%, 10%, 25%, 50%
and 100% power levels.
Push the button again to repeat the sequence. The 12V Dimmer remembers the last
setting even if power is interrupted.
One or more external pushbuttons can be connected to the 12V Dimmer Kit V2 via
the “STEP” connector
on the PCB. Use normally-open (NO), single-pole single-throw (SPST) momentary
action switches

Package includes

• 
  DC 12V 5A LED Single Channel Dimmer

  
  Connect your power supply to the “POWER” terminal block. Make sure to observe
  the correct polarity ( + and – ). Connect your load to the “LOAD” terminal
  block. The correct polarity is indicated on the PCB

  
  Connect the load wire at first,
  following by the power wire.

  
  please ensure short circuit cannot occur between
  connecting wire before you turn on the power

   

  Warning

  The input voltage of this controller should be follow the
  specifications. other high voltage would most probably destroy it.
  Connect the wires of the controller and LED fittings as per the
  instruction.

  1,Never connect two wires directly in case of short
  circuit.

  2,Lead wire should be connected correctly according to
  colors
  that connecting diagram offers.